User's Manual

Step 3. Install the two butterfly nuts
onto the threaded rods. Tighten the
plate onto the underside of the table by
hand.
Step 4. Plug the power cable into the
nearest power socket. About 90 seconds
after the riser powers on, a home page
appers on the tablets screen for a few
seconds. DO NOT touch the screen
as the system is booting up. After the
home page disappears a static image
appears. Once you see the static image
,press the button that is displayed on the
screen.
Step 1. Place the interactive riser
onto the display table. Make sure the
threaded rods, power cable and the
registration blocks go into the slot in the
table.
Step 2. Install the plate onto the
threaded rods until plate is flush with
the underside of the display table.
Installation Instructions
Page 6
Rear View
Page 7
11 2 3 4 5 6 7 3 2
No. Description
1 Joplin Power Ports
2 Home Power Ports
3 Joplin/Home USB Update Port
4 Power Switch
5 System Reset Button
6 Update Screen Contents Port
7 Update System Software Port
The diagram below shows the dierent ports located in the back of the
display. The Joplin and the Home can be installed on either side of the riser
so there are 2x ports in which the Home and Joplin can be powered and
updated.