User's Manual

2
www.i-display.com
IMPORTANT SAFETY INSTRUCTIONS
MAIN SUPPLY
This equipment is designed to operate from a 100-240 Volt, 50/60Hz AC main supply. The use of other power
sources may damage it. Check that the voltage marked on the rating plate located at the rear of the power
adaptor states 100-240V. The manufacturer will NOT accept responsibility for damage or injury caused by
connecting to the wrong voltage.
MAIN ADAPTOR
The power adaptor supplied is compatible with a standard mains socket.
NB. If the power adaptor or lead gets damaged, it must be replaced by a qualified service agent with an
approved adaptor of the same type and rating.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must
accept any interference received, including interference which may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio / TV technician for help.
In accordance with FCC requirements, changes or modifications not expressly approved by
manufacturer could void the user’s authority to operate this product.