Users Manual

RFID Tags Supported
Supports ISO15693 tags
Outform development will focus on ISO15693
Anti-collision algorithm: up to 4 tags on the same antenna (for ISO15693 only)
Indicator Lights
PWR- device itself is powered and working
ODC pwr- is on when ODC bus is receiving power
ODC RX- blinks when device receives ODC command
CFG- button used for assigning ODC address manually
ANT 1, ANT 2, ANT 3, ANT 4- shows which antenna is connected and blinks every time the OSM RFID
does a “pull request” to check if a tag is registered by the antenna (default is 200ms per pull request, so
will be blinking constantly when antenna is connected).
Antenna Detection
Each antenna can detect up to 4 tags at the same time, for a total of 16 simultaneous reads
Tags can be read from no farther than 50mm away (on the average)
Antennas must be able to read through material of up to 30mm thickness, assuming material is
non-ferrous.
Materials to be tested: Solid wood, acrylic, engineered wood (MDF/OSB), corian, ABS, glass.all
at various different thicknesses
Need to create testing matrix
Hardware
MCU unit
STM32F103RG.