Product Manual

Outdoor Water Solutions
2300 S. Old Missouri Rd, Springdale, AR 72764
866-471-1614, www.outdoorwatersolutions.com
Step 1: Preparing install area
Choose a proposed Direct Drive “DD” solar system location. Clear any debris in area where proposed install
site will be located. Check for trees that may be obstructing solar panels (trim if needed).
Step 2: Installing 5ft- 1 ½” round galvanized solar panel pole
Using a digging shovel or post hole shovel, dig hole 2ft-2 1/2ft in depth and 2-3ft in diameter. Insert pole into
center of hole. (See figure #1) Galvanized solar panel pole must be at the least 2ft deep in hole. Insert rebar
piece into predrilled hole. This is for anchoring to pole into cement. Using level, make sure galvanized pole is
level; then, add concrete. After concrete has been poured, double check pole to make sure pole is level. (See
Figure #2) Brace pole until concrete has hardened.
Figure #1 Figure #2