LED Light Kit Install Instructions for LIGHT-KT sales@outdoorrooms.com | 1.866.303.4028 | outdoorrooms.
Table of Contents Included With This Kit…………………………………….…..…….3 Setup Instructions………………………………..…….…………4-5 Wiring Diagram………………………………………….………….…5 Install Instructions……………………………….………….….……6 Install Diagram…………………………………………………...……7 Service Parts and Optional Components……………………..
Included With This Kit 24” LED Strip with 24” extension wire attached, 4 pin female connector and foam adhesive backing (X2) LED controller and Remote (X1 Each) 110V to 12V DC , 40 W power supply (X1) Power Splitter with 4 pin female connectors (X1) 4 Pin Male Connectors (X10) Plastic Wire Clips (X10) 3
Setup Instructions Before installing Light Kit, remove all components from box and make sure all components are included and working properly. Avoid Bending Strips at sharp angles, this can put stress on the strip and cause it to fail over time Keep wires away from hot surfaces of burner 1. Plug LED controller into Power Supply (or optional rechargeable battery pack). 2. Plug power splitter into LED controller using 4 pin male connector.
3. Plug LED light strips into power splitter using 4 pin connectors. Note the orientation of the plugs, arrows on each connection should align. LED Strip Power Splitter Align arrows on connections from LED strips to Power splitter. 4. To test lights, plug power source into a wall outlet, extension cord, or optional battery pack. Use the Remote to turn LEDs on/off and change colors. Refer to instructions included with remote for a full list of remote functions.
Installation Instructions (Your installation may vary) Before installing Light Kit, remove all components from box and make sure all components are included and working properly. Avoid Bending Strips at sharp angles, this can put stress on the strip and cause it to fail over time Keep wires away from hot surfaces of burner 1. 2. 3. 4. Lay out LED strips and wiring to ensure you have enough wiring to complete your installation. Ensure mounting surfaces are clean and free of debris.
Installation Diagram Controller Light Strip Splitter Power Supply 110V plug Feed wires through gap in access door, or other opening. Door Mounting Tabs for Power supply If installing Light kit on an Outdoor Greatroom Product, it is suggested to run wiring through gap in the access door in the base, in order to keep wiring hidden and out of the way. If desired, a 5/8” hole can be drilled through the base to feed LED extension wires through, and wiring can be completed inside the base.
Service Parts and Optional Components LK-01 40w power adapter LK-02 and LK-03 LK-04 RGB LED controller (LK-02) and Remote (LK-03) 4-pin power splitter LK-05 2 ft. LED Light Strip w/ 2 ft. extension wire, adhesive foam backing LK-08 LK-07 4-pin connector (10pk) LK-10 2 ft. Extension wire 4 pin connector ends. Plastic Wire Mounting Clips (10pk) LK-12 LK-11 Foam Mounting Tape (Roll) 2 ft. Light Strip, 4 pin connection at each end, no extension wire, and foam adhesive backing.
