Mantel Sample Kit Manual

Required Tools

 Power Drill with Phillips bit

For fastening the mantel to wall surface

 Leather Gloves

To protect hands from rough edges on concrete

 Utility Knife

To cut and remove packaging

 Level

To ensure mantel is parallel to floor

 Tape Measure

For locating and centering mantel

 Stud Locator

For locating studs inside a finished wall

 Pencil

For marking stud locations

42476 REV B 04.09.18

! IMPORTANT !

The fasteners supplied with this furnishing are intended for use in standard wood stud walls only. Minimum

wall stud size required is 2”x 4”, with drywall or finished wall surface ranging from ½” to ¾” thick. For all other

mounting surfaces, use appropriate fasteners as specified by local building codes or other jurisdiction. For

mounting to other wall types, if you are at all unsure of the correct fastening method, contact your local

building official. Improper mounting may lead to property damage, injury, or death.

MANTEL “SUPERCAST” MATERIAL MEETS NON COMBUSTIBILITY STANDARDS IN ACCORDANCE WITH ASTM E136.

Gallery and Modern Mantels Sample Kit

Installation Instructions For:

LG-MNTL-K

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

When using the furnishing, basic precautions should always be followed, including the

following:

 Read all instructions before mounting or using the mantel

 Use the furnishing only for its intended use as described in these instructions.

PAGE 1
Gallery and Modern Mantels Sample Kit Installation Instructions For: LG-MNTL-K Required Tools  Power Drill with Phillips bit For fastening the mantel to wall surface  Leather Gloves To protect hands from rough edges on concrete  Utility Knife To cut and remove packaging  Level To ensure mantel is parallel to floor  Tape Measure For locating and centering mantel  Stud Locator For locating studs inside a finished wall  Pencil For marking stud locations IMPORTANT SAFETY INSTRUCTIONS SAVE THESE I
PAGE 2
Hanging Bracket #8 x 2-1/2” Wood Screw (QTY 4) NOTE: WOOD SCREWS SHOULD ONLY BE USED FOR MOUNTING THE MANTEL TO A WOOD STUD WALL OR OTHER SOLID WOOD SURFACE. Mounting Instructions    Check for damage. Do not use damaged components. It is required to mount the unit at wall stud locations (if applicable) for proper holding strength and weight distribution.