Non-Combustible Supercast Mantel Manual

Mounting Instructions

 Check for damage. Do not use damaged components.

 It is required to mount the unit at wall stud locations (if

applicable) for proper holding strength and weight

distribution.

 Be sure to follow your fireplace manufacturer’s clearances to

non-combustibles or local code if applicable when

determining a location for your mantel. Combustibles set on

a non-combustible mantle must meet clearance requirements

for combustibles.

1. Choose a location for your mantel and locate studs behind

the wall surface using a stud locator. Mark stud locations

with a pencil for reference in the next step.

2. Hold the Hanging Bracket up to the wall surface, centered

at the desired location, and ensure it is parallel to the

floor using a level.

3. Use a pencil to mark hole locations on the bracket, lining

it up with a minimum of 3 studs.

4. Insert the supplied #8 x 2-1/2” Wood Screws at the

marked hole locations, two screws per stud location as

shown below.