Mantel Sample Kit Manual

Mounting Instructions
 Check for damage. Do not use damaged components.
 It is required to mount the unit at wall stud locations (if applicable) for proper holding strength and
weight distribution.
 Be sure to follow your fireplace manufacturer’s clearances to non-combustibles or local code if applicable
when determining a location for your mantel. Combustibles set on a non-combustible mantle must meet
clearance requirements for combustibles.
1. Choose a location for your mantel and locate studs behind the wall surface using a stud locator. Mark stud locations with a pencil
for reference in the next step.
2. Hold the Hanging Bracket up to the wall surface, centered at the desired location, and ensure it is parallel to the floor using a
level.
3. Use a pencil to mark hole locations on the bracket, lining it up with a minimum of 2 studs.
4. Insert the supplied #8 x 2-1/2” Wood Screws at the marked hole locations, two screws per stud location as shown below.
5. Lift the mantel up so that the top edge of the bracket is approximately centered in the cavity at the back side and hold flush to the
wall surface. Carefully lower on to the hanging bracket and ensure the mantel is seated properly before placing the full weight of
the mantel on the bracket.
#8 x 2-1/2” Wood Screw (QTY 4)
NOTE: WOOD SCREWS SHOULD
ONLY BE USED FOR MOUNTING THE
MANTEL TO A WOOD STUD WALL
OR OTHER SOLID WOOD SURFACE.
Cross-
Cross-
14400 Southcross Drive West • Suite 100 • Burnsville, MN 55306
Toll Free: 1-866-303-4028 • [e-mail]
Thank you for purchasing an Outdoor GreatRoom Company
product! This product was made with pride in the USA.
Cross-section view
Cross-section view
42476 REV B 04.09.18
Hanging Bracket
Complete Sample View