Outback MATE3s Programming Guide

Page 55Page 54
900-0125-12-02 Rev A
©2017 OutBack Power Technologies. All Rights Reserved.
Specications
Specications
Notes
MATE3s Specifications
Firmware Revision
This manual applies to MATE3s System Display and Controllers with a rmware version of 001.001.xxx or higher.
FCC Information to the User
This equipment has been tested and found to comply with the limits for a Class B digital device when powered by a
DC source, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Consult the dealer or an experienced radio/TV technician for help.
Mechanical
Dimensions (H × W × D) 7 ½ × 7 1/16” × 1 5/8” (19 × 17.9 × 4.2 cm)
Shipping Dimensions (H × W × D) 3 ¼ × 9 × 13 ½” (33.7 × 22.9 × 34.3 cm)
Weight 1.4 lb (0.64 kg)
Shipping Weight 3.0 lb (1.36 kg)
Ports RJ45 for proprietary OutBack HUB communication (×1), RJ45 Ethernet port (×1)
Nonvolatile Memory 64 Mb (for internal data logs and MATE3s configuration settings)
Interface Display Liquid Crystal Display (LCD)
Control Keypad 4 soft keys, 6 hot keys
4 navigation keys, 1 control wheel with Enter button
Status Indicators 9 LED indicators
Battery (for real-time clock and internal memory) CR2032
Communication Protocol Proprietary OutBack network
Interconnection Cabling Standard Category 5 OutBack proprietary
PC Interface Category 5
Environmental Rating Indoor only
Warranty 5-year standard
Regulatory
Emissions Indoor only
Listings UL 1741 1st Edition; 2005 Version, CSA 107.1-01
Compliance CE Conformance European EN 55022 Class B