Outback MATE3s Programming Guide

Page 47Page 46

900-0125-12-02 Rev A

Prole Wizard

Notes

W-5. Using Existing Profiles

This section shows the process of saving the prole and creating names for each le. The screen

progression shown here is the same whether A is selected in the New Prole, Existing Prole, or

Restore Prole menus.

To save a prole to an SD card:

If other proles have been saved on the SD card, a list will be displayed (L).

Choose Option 1 or 2 below.

NOTE: If the SD card is empty, pressing <Save> will automatically default

to Option 2 below.

1. Select a name on the list with the control wheel. Press the <Save> soft

key (N) to save the new settings over the selected prole. Saving to SD

Card will be displayed. Proceed to 3.

2. Press the <New> soft key (M) to create a new prole name.

(8 characters maximum)

● Use the control wheel to scroll through the available characters.

● Use <> or <> to move to the desired character location.

● Use <Delete> to erase characters when highlighted.

Press <Save> to save the new prole name. Saving to SD Card

will be displayed.

In either case:

3. Wait for the conrmation screen to appear. After the screen appears,

press <Continue> to return to the Setup Complete screen J.