Installation Guide

57
NOTE:Foraglobalchargercommandtowork,alloftheOutBackproductsmustbeconnected
toaHUB.eCHARGERMODECONTROLaectsbothFXSeriesInverters/Chargers
andOutBackChargeControllers.isrequiresthattheFXandOutBackChargeController
rmwareversionssupportthisfeature(Seepage129,Troubleshooting, if this command fails to
function).
Tostopanequalizingprocess,returntotheEQUALIZECONTROLscreenandpressthe
<STOP> sokey.ToreturntotheEQUALIZECONTROLscreen:
• Pressthe<AC IN> hot key four times.
• Pressthe<EQ> so key.
• Pressthe<STOP>sokeyontheEQUALIZECONTROLscreen.
AC INPUT CONTROL
Hot Key
CHARGER MODE CONTROL
Global charger mode
BULK EQ OK
EQUALIZE CONTROL
eq enabled Yes
START STOP OK
MAIN--------------------------
1:35:04p
SUM STATUS SETUP ADV