Installation Guide

54
• WhenanOutBackHUBisemployed,theGENSTARTCONTROLonlyaectstheFX
programmedastheAGSPORTintheAGSsetup.isistheHUBPortconnectedtothe
FXwiththegeneratorstartrelay.
<OFF>manuallyoverridesAGSmode.Pressing<OFF>bringsupMAN-OFFindicatingthe
user manually shut o the generator.
<AUTO> allows the MATE to automatically start and stop the generator according to the
settingsprogrammedintheADVANCEDAGSmenu.Pressing<AUTO> brings up either
AUTO-OFForAUTO-ONdependingontheFXprogramming.
<ON>manuallyoverridesAGSmode.PressingitbringsupMAN-ONindicatingtheuser
manuallyturnedthegeneratorON)
<OK>ReturnstothepointinthemenusystemwhereyouenteredtheGENSTART
CONTROLscreen.
GEN START CONTROL
currently: MAN-OFF
OFF AUTO ON OK
PRESSTWICE:
• eGENSTARTCONTROLscreenallows
changes to the Advanced Generator Start
(AGS)mode.
• eAGSsettingsonlytakeeectwhen
Advanced Generator Startisenabled(Seethe
AGSModesectionformoreinformation).
NOTE:isdoesnotcontroltheGenAlert
function.
NOTE:ToresetanAGSerror,press<OFF> and then press <AUTO>.
PRESSTHREETIMES:
CHARGER CONTROL
currently: AUTO
OFF AUTO ON OK
• eCHARGERCONTROLscreenappears.
• isallowstheoperationoftheFXbattery
charger to be preset for an available AC source.
• WhenanOutBackHUBisemployed,the
CHARGERCONTROLonlyaectstheMaster
FXconnectedtoPORT1.eMasterFXthen
givesthesamecommandtoallslaveFXs.