Installation Guide

53
AC INPUT CONTROL
currently: DROP-HBX
DROP USE OK
AC INPUT CONTROL
currently: USE-HBX
DROP USE OK
or
• eACINPUTCONTROLscreenis
called up, allowing the user to connect or
disconnecttheFXtoanACinputsource.
• IfaHUBisemployed,ACINPUT
CONTROLonlyaectstheMasterFX
connectedtoPORT1;theMasterFXthen
givesthesamecommandtotheSlaveFXs
AC INPUT CONTROL
currently: USE
DROP USE OK
<USE>enablestheFXtoconnecttoanACinputsource.
<DROP> disconnects the AC input source but will allow it to be reconnected if the “low
batterycut-osetpoint”occursortheFXisoverloaded.
<OK> returnstothepointinthemenusystembeforeyouenteredtheACINPUTCONTROL
menu cycle.
If HBX Mode is enabled, the AC INPUT CONTROL will read:
PRESSONCE:
INV
Hot
Key
AC IN Hot Key
e AC IN “hot” key allows direct control of the AC input from anywhere in the menu system.
e yellow LED indicator above the AC IN “hot” key has three settings:
• Flashing - an AC source is available, but not connected
• Continuously On - the AC source is connected and in use
• O - no AC source is present
enumberofACINkeypressesdetermineswhichmenuiscalledup.
MAIN--------------------------
1:35:04p
SUM STATUS SETUP ADV