Installation Guide

49
OUTBACK CHARGE CONTROLLER STATUS METER Screens
ToviewtheCCSTATUSscreens,returntotheMAINMenu,pressthe<STATUS> so key and then choose
theCContheSTATUSchoose productscreen.eSTATUSscreensincludeMODE,METER,andSETP(SET
POINT).InSTATUSMode,theseChargeControllerfunctionscanbeviewedbytheMATE,butnotchanged.
mode: Silent P00
in 33.2 vdc 0 adc
out 13.7 vdc 0 adc
DOWN STATUS PORT
STATUS/CC/METER----------P00
charger .0 kwh
kwhrs
DOWN UP TOP PORT
STATUS/CC/METER-----------P00
charger 0 w
watts
DOWN UP TOP PORT
STATUS/CC/METER-------------P00
charger +000 adc
amps dc
DOWN UP TOP PORT
STATUS/CC/METER-----------P00
panel 33 vdc
voltage
DOWN UP TOP PORT
STATUS/CC/METER-----------P00
battery 13.7 vdc
voltage
DOWN UP TOP PORT
STATUS/CC/METER---------------
end of meter menu
UP TOP STATUS
STATUS/CC-----------------
MODE METER SETP MAIN
Press <SETP> to view the
SETPOINTscreens
CHARGE CONTROLLER METER Screens
• Mode/pv/in/bat/out:displaysthechargermode,thePVarrayvoltage,theincomingPVamps,the
battery voltage, and the outgoing amps to the battery
• charger watts: charger output measured in watts
• charger kwhrs: kilowatt hours produced today by the Charge Controller
• charger amps dc: the amount of amperage the Charge Controller is sending to the battery
• battery voltage: current battery voltage
• panel voltage:currentvoltagefromthePVarray
NOTE:All OutBack Charge Controller screens are displayed as CC screens on the MATE.
STATUS/CC/METER-----------P00
charger 0 ah
amp hour
DOWN UP TOP PORT
STATUS/CC/METER-----------P00
CC rmware revision
001.009.003
DOWN UP TOP PORT