Installation Guide

42
FX STATUS MODE Screens
STATUS/FX/PAGE1------------------
choose category:
MODES METER BATT PG2
STATUS/FX/MODE-----------P00
ac in control: USE
CHANGE
DOWN UP MODE PORT
STATUS/FX/MODE------------P00
inv control: ON
CHANGE
DOWN STAT MODE PORT
STATUS/FX/MODE------------P00
chr control: ON
CHANGE
DOWN UP MODE PORT
STATUS/FX/MODE-------------P00
eq enabled: No
CHANGE
UP MODE PORT
STATUS/FX/MODE-------------P00
aux control: AUTO
CHANGE
DOWN UP MODE PORT
STATUS/FX/MODE------------P00
inv control: ON
CHANGE
DOWN STAT MODE PORT
STATUS/FX/PAGE1--------
choose category:
MODES METER BATT PG2
Push <STAT> to return to the
choosecategorySTATUSpage.
Pressing the <METER> so key
bringsuptherstMETERscreen.
Push <UP> until the inv
control screen appears.
MODE Screens
• Pressingthe<CHANGE MODE> so key on any
MODE screen allows the user to change the operation
of that individual mode, i.e., activate the function, shut
ito,etc.Aerchangingtheoperation(orleavingit
alone),theuserpressesthe<OK> so key to return to
the MODE screen whose operation was changed. Press
the <DOWN>sokeytoviewthenextmode.
• inv control:showsthestatusoftheinverterfunction*
• AC in control:theFXacceptsordropsanACsource*
• chr control:showschargeractivity*
• aux control:controls12VDCand0.7ADCloads
which can be used to run a fan, activate an alarm, sig-
nalageneratorstartandotherlow-powerfunctions*
• eq enabled:showsstatusoftheequalizerecharging
cycleandallowsusertostartorstopthecycle*
*esemodescanbecontrolledandadjustedingreater
detailintheINVERTER,CHARGER,andAUXILIARY
menusandthroughtheACINhotkeyrespectively.