Installation Guide

41
Reading a STATUS Screen
STATUS/FX/PAGE1---------------
choose category
MODES METER BATT PG2
STATUS/FX/PAGE2---------------
choose category
PG1 ERROR WARN PG3
STATUS/FX/PAGE3---------------
choose category
PG2 DISCON SELL MAIN
• MODE:afunctioningconditionorstateofoperation
• METER:displaysinverterandchargeractivity,includingoutputandinputACvoltage,and
AC inverter, charger, and input current
• BATT:displaysthebatterytemperature,voltageandthevarioussetpointsforthedierent
recharging cycles as well as the time remaining to complete any of those cycles
• PG2:pressingthe<PG2>sokeyopensthenextselectionofSTATUSscreens
• ERROR:variousFXerrorsandtheircauses;anerrorcanshuttheFXdown
• WARN(ING):FXwarningsituations;warningswillnotshuttheFXdown
• PG3:Pressingthe<PG3>sokeyopensthelastSTATUSscreen
• DISCON:liststhereasonstheFXdisconnectsfromanACsource
• SELL:displaysanumberrepresentingthereasontheFXstopssellingpowertothegrid;this
numberisusedbytechniciansfortroubleshootinggrid-tiedFXunits
e second line
indicatestheFX
or Charge Con-
troller MODE
e status of
“inv(erter)
control”is“ON.”
Pressing the <CHANGE MODE> so key
changes the operation of the mode shown
on the screen; it does not change to another
mode altogether. To change modes, press the
<DOWN> so key.
TochooseanFX
on a specic Port,
press the <PORT>
so key.
STATUS/FX/MODE----------- P00
inv control: ON
CHANGE
DOWN STAT MODE PORT