Manualshelf

Installation Manual and Specifications

ManualsBrandsOutback Power ManualsInverter AccessoryOutback Power GSLC Empty
31323334353637383940
Assembly
900-0123-01-01 Rev A
31
Mounting the HUB Communications
Manager
The GSLC provides mounting holes to support a HUB Communications Manager.
Figure
25
Mounting the HUB Product to the GSLC Enclosure
To mount the HUB Communications Manager to the side of the GSLC enclosure:
1. Locate the mounting holes on the side of the GSLC enclosure as shown in Figure 11 on page 18.
2. Remove the knockouts and add bushings.
3. Align the HUB (vertically) over the mounting holes with the HUB product’s ports facing forward.
4. Insert the mounting screws from the outside into the GSLC enclosure. The mounting screws are
provided with the HUB product.
5. Tighten until secure, but do not over-tighten.
6. Install CAT5 cabling as needed.
7. Install the protective shield for the HUB product.
Mounting
Screw
Mounting
Screw