Installation Manual and Specifications

Installation

900-0123-01-01 Rev A

Mounting FLEXmax Charge Controller

The GSLC enclosure accommodates up to two FLEXmax charge controllers and a HUB

Communications Manager.

NOTE

: The following instructions are for the FLEXmax 60 or FLEXmax 80 only. The FLEXmax 100

charge controller connects directly to the wall and does not need additional brackets.

Figure

Mounting the Charge Controller to the GSLC Enclosure

To mount the FLEXmax

Charge controller to the side

of the GSLC enclosure:

1. Align the brackets to the

mounting holes and secure the

brackets to the sides of the

enclosure with the hardware

provided with the brackets.

2. Note the location of knockouts on

both the charge controller and

the GSLC. (See page 18.) The

holes will align when the brackets

are used. Remove knockouts if

necessary and insert bushings.

3. Align the charge controller with

the center hole on each bracket

and secure with the hardware

provided with the brackets.

Dual Charge

Controller Bracket

(

-CCB2

)

4. Secure to the bottom bracket.

NOTE: This illustration shows only brackets for a

single charge controller (FW-CCB). Dual

charge controller brackets (FW-CCB2) are

also available. The installation instructions

for FW-CCB and FW-CCB2 are similar.