Installation Manual and Specifications

Assembly

900-0123-01-01 Rev A

Figure

23b

Mounting the GSLC (continued)

7. Realign the GSLC along the bottom of the inverter and slide the mounting screws into the

keyhole slots.

8. Secure the enclosure to the mounting surface using all four mounting feet holes.

9. Using the bolts provided on the Radian inverter’s battery terminals, connect the terminals to

the GSLC’s inverter bus bars. Tighten to the value shown in Table 1 on page 22. For more

information on the Radian terminals, see the inverter Installation Manual.)

10. Leave the door and interior cover removed until all components have been installed and all

wiring is complete.

Bottom Screws

Keyhole Slots

...continued from the previous page.