Installation Manual and Specifications

Installation

900-0123-01-01 Rev A

Mounting on the Inverter

IMPORTANT:

The Radian inverter and GSLC are intended for indoor use only. Ensure the

mounting surface is strong enough to support the full weight of the Radian

inverter/charger and the GSLC. Use a minimum 3/4" (19 mm) sheet of plywood

to strengthen the wall surface if required.

Figure

Mounting the GSLC

To mount the GSLC to the Radian inverter:

1. Install the inverter on the mounting bracket.

Remove knockouts from the bottom of the

inverter if necessary and install bushings.

2. Back out bottom screw(s) approximately 1/4"

(0.6 cm) to 3/16" (0.5 cm).

3. Remove the front and interior covers from the

GSLC if necessary (as described on page 21).

4. Align the GSLC along the bottom of the inverter

and slide the bottom screws into the keyhole slots.

5. Hanging the GSLC from the screws and holding it

flush against the bottom of the inverter, mark the

spots for the holes for the mounting feet. These

are located in the rear of the GSLC and are

marked below.

6. If using wall anchors (included): Remove the

GSLC. Using a 3/8" (10 mm) drill bit, drill leader

holes for the hardware to be used to secure the

GSLC to the surface. Install the wall anchors.

If mounting on a solid surface like plywood, this

step can be skipped.

Bottom Screws

Mounting Feet

Holes (

14"

(35.6 cm)

12.5"

31.8 cm

Continued on the next page....

Keyhole Slots

Keyhole