Installation Manual and Specifications

Installation
26 900-0123-01-01 Rev A
Installing DC Shunts
Figure 21 DC Shunts
A single 500 Adc/50 mV shunt is
included with the GSLC. Up to two
more shunts can be installed as
needed. These shunts are used in
conjunction with the FLEXnet DC
battery monitor. See page 35 for
more instructions on wiring.
To mount DC Shunts:
1. Four mounting holes are located
to the lower left of the first shunt.
Center each shunt across one
pair of mounting holes. These
should line up with the mounting
holes built into each shunt.
2. Using the screws included with
the shunt, attach each shunt to
the GSLC enclosure.
3. Tighten the screws until secure,
but do not over-tighten.
NOTE: The GS-SBUS can be
purchased and installed to
connect the three shunts
together. See Figure 30 on
page 37.
Mounting Holes for
Additional Shunts
Pre-installed
Shunt
Additional Shunt Placement