Installation Manual and Specifications

Installation
22 900-0123-01-01 Rev A
Installing the Internal Hardware
Table 1 Requirements for Circuit Breakers and Bus Bars
Item Terminal/Bolt Size Torque Requirements
Inverter Positive (+) Bus Bars M8 60 in-lb (6.8 Nm)
Shunt Bolts 3/8" 60 in-lb (6.8 Nm)
DC Positive (+) Cable Plate Top Holes (x3) 60 in-lb (6.8 Nm)
Bottom Holes (x7) 50 in-lb (5.7 Nm)
Circuit Breaker Studs
M8 20 in-lb (2.3 Nm)
1/4" 35 in-lb (4.0 Nm)
5/16" 50 in-lb (5.7 Nm)
3/8" 225 in-lb (25.5 Nm)
Figure 17 DC Positive Cable Plate (FW-BBUS)
Top Holes
Bottom Holes
0.5" (12.7 mm)
0.31" (8 mm)
0.4" (10 mm)
NOTE:
The DC Positive (+)
Cable Plate (FW-BBUS) is
not included with models
GSLC175PV1-120/240,
GSLC175PV1-230,
GSLC-PV1-300VDC, or
GSLCPV1-300VDC-230.
It cannot be used with
these models.