Installation Manual and Specifications

Assembly

900-0123-01-01 Rev A

Remove Front Door

Figure 15 Removing the Front Door from the GSLC

Remove Interior Cover

In order to make any wiring connections or to install components, the interior cover must be

removed to expose the enclosure interior. (This cover is sometimes called the “dead front.”)

Figure 16 Removing the Interior Cover from the GSLC

Lift up to remove.

To Remove the Front Door:

1. Open the door to about 90 degrees.

2. Lift the hinges out of the slots at the

inside edge.

Open to 90 degrees

(shown partly open)

To Remove the Interior Cover:

1. Remove the three screws along the top of the

enclosure (with one star washer).

2. Remove the three screws along the bottom of

the enclosure (with one star washer).

3. Lift the front cover off the enclosure.

Remove (×3)

Interior

Cover