Installation Manual

Introduction
8 900-0197-01-00 Rev A
Components and Accessories
Table 1 Components and Accessories
Components to be Installed Accessories Included
Battery Terminal Cover, red FX Mobile Series Installation Manual (this book)
Battery Terminal Cover, black FX Mobile Series Operator’s Manual
AC Plate “WARNING ELECTRICAL SHOCK” sticker
DC Cover (DCC) or Turbo Fan Silicone Grease Packet
Remote Temperature Sensor (RTS)
Figure 2 Components
DCC (DC Cover)
This covers the DC terminal area on vented inverters. The
DCC provides space to mount other components such as a
DC current shunt.
AC Plate
This plate is used for installations which do not utilize OutBack’s
optional FLEXware conduit boxes. The knockouts are used to
install strain relief for flexible cable.
NOTE: This plate is not to be connected to conduit.
Battery Terminal Cover
These protect the terminals from accidental contact. They are
made of stiff plastic with a snap-on design.
Always keep covers installed during operation.
Turbo Fan Cover
Included in place of the DCC on sealed inverters. Convectively cools
chassis with the external OutBack Turbo Fan to allow maximum power.
NOTE: Do not install the Turbo Fan on a vented inverter.
NOTE: The DC Cover or Turbo Fan does not replace the battery terminal
covers. These covers must be installed in addition to the DCC or fan.