Quick Start Guide

General Wiring
Neutral
Ground
30 A Circuit
Breaker
(Maximum)
AC IN
AC Source
(single)
Ground
Electrode
Conductor
HOT
NEUTRAL
GROUND
Bypass
Outlet
PV Combiner Box
900-0133-01-00 REV B.vsd
©2013 OutBack Power Technologies. All Rights Reserved.
AC Subpanel
N
L1
L1
L1
L1
N
N
Photovoltaic Array (PV)
Battery Status
GFDI
AC IN
INV
MAIN----------------
3:02:14P
SUM STATUS SETUP ADV
Battery Bank
Vented Battery Enclosure
MATE RTS
(RTS)
In 23.2 V 0.0 A
Out 27.6 V 0.0 A
0.000 kW 0.0 kWH
AUX: OFF Sleeping
PV Circuit Breaker
Connects to the terminal on the circuit breaker
that is opposite the inverter DC cable.
1
Charge Controller
1
Loads
(230 Vac)
O
I
O
I
O
I
O
I
O
I
O
I
O
I
O
I
AC Distribution
Panel
(or disconnect device)
IMPORTANT: Example only. Actual wiring may vary.
Factory wiring not shown. All configurations must
comply with local and national electric codes. Consult your
local electric authority to ensure compliance.
Neutral
HOT L1
Ground
AC LEGEND
L1
N
If the FLEXnet DC battery monitor
is not installed, the DC shunt will
not be installed.
If the DC shunt is not installed,
connect the DC negative (–) cable
directly to the DC negative (–)
terminal on the inverter.
2
DC Negative (—) Cable
DC Negative (—)
Terminal on the
Inverter
IMPORTANT:
Indoor installation only.
Negative
Positive
Ground
DC LEGEND
2
N
30 A Circuit Breaker
(Maximum)
Output
Input