Outback FM80 User Manual

MATE-Class Screens
900-0009-01-00 Rev D 83
AUX Menu
Figure 90 ADV Menu for the AUX Features
Navigation for ADV/CC/AUX
o
<
DOWN
>
moves to the next menu item in
the diagram.
o
<
INC
>
increases the value of the selection.
o
<
DEC
>
decreases the value of the selection.
o
<
PORT
>
directs the system display to read
the next device (port) on the HUB.
o
<
TOP
>
returns to the
CC/PAGE2
screen.
o
<
ADV
>
returns to the
choose device
screen.
o
<
MAIN
>
exits the Advanced menus and
returns to the Main Menu (see page 79).
CC/AUX
The Aux screens adjust the same settings that
are available on the Aux screen in the FLEXmax
(see page 30).
Aux
mode:
o
vent fan
o
pv trigger
o
error output
o
night light
o
float
o
diversion: relay
o
diversion: solid st
o
low batt(ery) disconnect
o
remote
The
remote
mode also can be used for the
system display’s AGS function. See page 44.
NOTE
: The AGS function is only intended for
use in systems with a HUB, inverter, and
FLEXmax. If the system display connects only to
a FLEXmax, the only AGS function that will work
is the DC genset programming. The other AGS
functions will not work properly.
NOTE
: The system display must have firmware
revision 4.1.6 or higher for AGS to work.
aux control
o
ON
o
OFF