Outback FireRaptor Module Level Application Note

Application Note
©2019OutBackPower,Arlington,WA98223RB‐GE‐4/10/19Page6of11  
SkyBox
Here is an example of how to wire the FireRaptor with a SkyBox unit. The key is to give the SkyBox a
closed-circuit signal during normal operation and an open circuit signal during a rapid shutdown event.
Two different options are:
 Wiring across a dry contact that opens during a rapid shutdown event, and connecting that to the
SkyBox RSD input on the C
ONTROL WIRING TERMINAL BLOCK (also called the AUX terminals).
 Connect the 24 Vdc output of the switch to a 24-volt-rated normally open device (OBR-16-DIN)
that will open upon loss of 24 Vdc and close with the presence of 24 Vdc.
Figure 6 Example configuration of a SkyBox with the FRS-01