Quick Start Guide

Setup

900-00263-01-001 REV B

To install the CSIP Bridge:

1) Connect any computer to the same local area network (Ethernet LAN) as the MATE3s

2) Connect the CSIP Bridge to the computer using the provided USB cable (at C)

3) After a short delay, the CSIP Bridge will appear on the computer as a USB-connected device.

4) Click START to bring up the following screen.

5) Bring up the Configuration screen by following the instructions on the image below.

Click the IP address of the active connection.

6) Fill out the Configuration screen. Populate all fields with the values from the appropriate devices.

Configuration is complete.

To finish installation:

7) Remove power. Unplug the USB cable from C.

8) Connect the CSIP Bridge to the ne

twork.

Conn

ect a cable to the network ro

uter.

Conn

ect the other end of the cable

to the

IP Bridge at D

9) Repower th

e CSIP Bridge using the

USB

AC wall ch

arger. Connect the USB cable to C

Plug the wall ch

arger into an

electrical outlet.

10)

CSIP Bridge operation is automatic.

After

configu

ration, no user interaction is required.

If the MATE3s is assigned a new IP address, the

CSIP Bridge configuration screen must be updated

to reflect the change. Note that an automatic

reboot should not result in a new IP address when

a DHCP server is used, as the server retains a

MAC address table and is able to reassign the

same IP address.