Warranty

OutBack Batteries

Limited Warranty

OutBack Power Technologies, Inc. ("OutBack") provides a limited warranty ("Warranty")

against defects in materials and workmanship for its EnergyCell PLC battery products

(“Product”). This Warranty does not apply to a Product used in applications other than those

described here.

Table 1 Warranty Term

Location Warranty Term

United States and Canada

6 years (72 months)

European Union and United Kingdom

5 years (60 months)

Other countries and areas

4 years (48 months)

The Product will be free of defects in material and workmanship for the period specified above

according to rated capacity range, commencing on the date stamped on each Product.

OutBack must be notified immediately upon suspicion of any possible defects

within 30 days

after receiving Products and must be allowed to inspect any questionable installations.

If OutBack determines the Product(s) to be defective due to material or workmanship, it will

repair or replace them, at its option, without charge. A Product will not be considered defective

unless it fails to deliver 70% or less of its rated capacity during claimed warranty period after

fully charging.

This Warranty applies to the original Product purchaser, and is transferable only if the Product

remains installed in the original use location. This is in lieu of all other warranties, expressed or

implied including any warranties which extend beyond the description of the face hereof.

In no

event shall OutBack be liable for consequential or incidental losses or damages.

Registration, installation and periodic inspection reports are to be maintained by the end user

and made available to OutBack on request as required to support any warranty claim. At least

once every six months, the user shall complete an inspection report recording readings and

record information of surface temperatures, charging/discharging profile, and internal ohm

reading of each Product under fully charged conditions. These records must be maintained for

warranty claim purposes.

All Product maintenance functions must be performed as recommended in the

EnergyCell PLC

Owner’s Manual

All Product(s) must be audited every six (6) months if stored above or below 77ºF (25ºC).

Product(s) must be given a freshening charge before dropping below 2.05 volts per cell

(12.3 Vdc for 12V pure lead carbon batteries), or after twenty-four (24) months of storage or

whichever occurs first. Product(s) should be given a freshening charge before final installation.

PAGE 1
OutBack Batteries Limited Warranty OutBack Power Technologies, Inc. ("OutBack") provides a limited warranty ("Warranty") against defects in materials and workmanship for its EnergyCell PLC battery products (“Product”). This Warranty does not apply to a Product used in applications other than those described here.
PAGE 2
Warranty Terms All claims are subject to the operating & warranty conditions below.
PAGE 3
Warranty Support Modifications No representative, salesperson, agent, distributor, or employee of OutBack is authorized to modify any of the terms of this Warranty, unless modifications are made in writing and signed by an authorized OutBack officer. This Warranty represents the entire agreement between OutBack and user with respect to the subject matter herein and supersedes all prior or contemporaneous oral or written communications, representations, understandings or agreements relating to this subject.
PAGE 4
Recycling Recycling Information IMPORTANT: Recycle Electronics and Batteries Batteries are considered hazardous waste and must be recycled according to local jurisdiction. Inverters and other electronics contain metals and plastics that should also be recycled. The following websites and phone numbers provide additional information for recycling electronic products and batteries. Environmental Protection Agency, USA Website: http://www.epa.