Outback Power FX and VFX Series Programming Manual

47
ADV/FX/STACK-----------P02
Stack 3ph Master
phase
DOWN INC DEC PORT
ADV/FX/STACK-----------P02
stack 1-2ph Master
phase
DOWN INC DEC PORT
ADV/FX/STACK------------P03
stack 3ph Slave
phase
DOWN INC DEC PORT
ADV/FX/STACK-----------P03
stack 1-2ph Master
phase
DOWN INC DEC PORT
ADV/FX/STACK----------P03
stack 3ph Slave
phase
DOWN INC DEC PORT
PRESS FIVE TIMES
Auxiliary (AUX) Functions
The AUX output provides a 12VDC, 0.7ADC max output at the AUX terminals to control either DC or AC
external loads. Typical loads include signaling a generator system to start, sending a fault alarm signal,
or running a small fan to cool the FX.
Press .
NOTE: Pressing and holding the  rst two soft keys
at the same time will always bring up the Main
Menu screen.
Push any soft key on the ADV/SETTINGS/
WARNING screen and go to the ADV/PASSWORD
screen.
MAIN--------------------------
12:12:16A
SUM STATUS SETUP ADV
ADV/SETTINGS/WARNING
changes made could adversely a ect
system performance
ADV