Outback Power FX and VFX Series Programming Manual

43
ADV/FX/STACK---------P03
stack OB Slave L2
phase
DOWN INC DEC PORT
ADV/FX/STACK----------P04
stack OB Slave L2
phase
DOWN INC DEC PORT
ADV/FX/STACK----------P04
stack OB Slave L2
phase
DOWN INC DEC PORT
Press the <PORT> soft key again
until Port 04 appears on the
screen.
Push the <INC> soft key three
times to set the stack phase to
OB Slave L2.
NOTE: Any additional FXs in the system can be programmed by pressing the <PORT> soft key to get
to the next FX and then press <INC> twice (OB Slave L1) for parallel stacking or three times for series
stacking. In this example, one FX (P02) is set to be in parallel with the Master (P01) and two FXs (P03 &
P04) to be in series with the Master.