Outback Power FX and VFX Series Programming Manual

40
After setting up your OutBack Parallel Stacking and establishing the Master and Slave order, shut o all
the AC input and output breakers and check your system via the following MATE screens:
ADV/FX/STACK---------P04
stack OB Slave L1
phase
DOWN INC DEC PORT
ADV/FX/STACK---------------
stacking setup
completed
TOP ADV MAIN
ADV/FX/STACK---------P04
power save level 3
slave adjust only
DOWN INC DEC PORT
From the ADV/FX/STACK power save level slave adjust only screen, press the <DOWN> soft key, the
<TOP> soft key, and then the <DOWN> soft key.
ADV/FX/STACK---------P04
power save level 2
master adjust only
DOWN INC DEC PORT
ADV/FX/STACK---------P04
power save level 1
master adjust only
DOWN INC DEC PORT
ADV/FX/STACK----------P04
power save level 0
master adjust only
DOWN INC DEC PORT
Verify this is the power save level
master adjust only screen. Press
the <PORT> soft key until P01
appears on the screen. Turn on all
of your FX AC Output breakers.
The Master FX’s “INVERTER” LED
should be solid and all the Slaves
“INVERTER” LED’s should be
blinking.
Press the <INC> soft key to adjust
the “power save level master adjust
only” from 0 to 1 and watch the
1st Slave’s “INVERTER” LED go solid.
When the “INVERTER” LED is on
solid, this means that the inverter
is on. When the “INVERTER” LED on
the Slave is blinking, this means the
FX is asleep.
Press the <INC> soft key once
to adjust the power save level
master adjust only to 2 and
watch the 2nd Slave’s “INVERTER”
LED turn on
ADV/FX/STACK---------P01
power save level 0
master adjust only
DOWN INC DEC PORT
ADV/FX/STACK---------P01
power save level 3
master adjust only
DOWN INC DEC PORT
Press the <INC> soft key once to
adjust the power save level master
adjust only to 3 and watch the
3rd Slave’s “INVERTER” LED turn
on. If the system has more than
three Slaves, keep increasing the
value in the power save level master
adjust only screen and verify that
each Slave’s “INVERTER” LED comes
on as expected. This check veri es
all FXs are stacked correctly.
Adjust the power save level
master adjust only to 0 by
pressing the <DEC> soft key.