Outback Power FX and VFX Series Programming Manual

NOTE: If you are doing OutBack Stacking, turn on the FW-X240 Auto Transformer breaker now. Otherwise, go

to the next step.

• Verify the AC voltage output through the MATE following path:

PATH

MAIN--------------------- STATUS------------ STATUS/FX/PAGE1------- Float P00 STATUS/FX/METER—P00

12.15:30p choose device: choose category: inv 0.0Kw zer 0.0kw output 117 vac

chg 0.0kw buy 0.0kw voltage

SUM STATUS SETUP ADV

FX CC DC MAIN MODES METER BATT PG2 DOWN STATUS PORT DOWN UP TOP PORT

BYPASS OUTPUT INPUT

With the programming

completed, turn the AC output

breakers ON with the AC

BYPASS on the AC breaker panel

switched to NORMAL.