Outback Power FX and VFX Series Programming Manual

32
ADV/FX/STACK----------P01
stack 3ph Master
phase
DOWN INC DEC PORT
3-Phase (3-ph) Slave
• Set the two Slave FX’s to 3ph Slave and make sure they are in Ports 02 and 03 of the HUB.
• There are no selections to di erentiate between phases B and C.
• When you set the jumper in the HUB for 3-phase, the HUB assigns each Slave to its phase. 3ph Slave
on HUB Port 2 is considered phase B.
• 3ph Slave on HUB Port 3 is considered phase C.
The FX has now been set to 3ph Master status.
ADV/FX/STACK----------P01
stack 3ph Master
phase
DOWN INC DEC PORT
From the 3ph Master screen, press until
P02 appears.
ADV/FX/STACK-----------P02
stack 1-2ph Master
phase
DOWN INC DEC PORT
Each new Port screen in the stacking menu will
open with 1-2ph Master displayed. To change the
stacking designation, press until 3ph
Slave appears.
ADV/FX/STACK----------P02
stack 3ph Slave
phase
DOWN INC DEC PORT
After establishing P02 as a 3ph Slave, move onto
P03 and repeat the procedure. Press when
 nished
.
PORT
INC
DOWN