Outback Power FX and VFX Series Programming Manual

22
3. After powering up the components, connect the MATE to the HUB.
a) Plug the MATE into the 1st MATE Port on the HUB.
b) The MATE will power up and should recognize any component connected to the HUB.
c) The MATE can then program the FXs.
d) The  fth MATE screen (“Port Assignment”) should display all the FXs and any OutBack Charge
Controllers in the system.
MATE Screens
PATH
G’day (C) 2004 Version Searching Port Assignment
OutBack Code a.aa for Devices 1> FX 2> FX 3> CC 4> CC
Power 5> 6> 7> 8>
Systems Serial #xxxxxxxx HUB Found 9> 10> 2M>
Screen EE b.bb
4. To verify the MATE recognizes each HUB connected FX and OutBack Charge Controller, disconnect
and then either (a) reconnect the MATE to view its boot-up and repoll sequence or (b) follow this path
to manually repoll:
PATH
M AIN--------------------- SETUP---------------- SETUP/MATE/PAGE1 SETUP/MATE/PAGE2 SETUP/MATE/COMM
12.15:30p choose device: mate code rev: 402 choose category: choose produce:
choose category:
SUM STATUS SETUP ADV FX MATE CLOCK CNT GLOW PG2 PG1 SUMRY COMM MAIN BACK REPOLL PC DEBUG
The FXs are now ready to be programmed according to the stacking options described in the next section.