OutBack Power Installation and User Manual

36
To debug the system, press the <DEBUG> so
key.
OntheDEBUGscreen,rstpressthe<VIEW>
sokeytobringupalistofHUBportswitha
count of communications errors for each port;
<RESET> allows you to reset the error counting
display(seenextscreen).
isisatypicalVIEWscreenshowingtheHUB
Ports and any communication errors in the
system. e numbered port with more than one
error will need correcting. Aer the errors are
corrected,alltheusedportswillreturnto000
or001valuesaerpushingthe<RSET> so key.
PressanysokeytoreturntotheSETUP/MATE/
COMM screen. To correct errors, please see “Er-
rorsandDebugging”inthesectionthatfollows.If
no errors are present, pressing any so key returns
tothepreviousSETUP/MATE/COMMscreen.
Press the <RSET> so key to clear the error-
counting display. Press the <BACK> so key
to return to the “choose category” screen. Press
<VIEW> to return to the previous screen.
SETUP/MATE/COMM--------------
comm errors:
BACK VIEW RSET
00:000 01:000 02:000
03:000 04:025 05:001
06:001 07:001 08:001
09:001 10:001 2M:001
SETUP/MATE/COMM--------------
comm errors:
BACK VIEW RSET
SETUP/MATE/COMM--------------
choose category:
BACK REPOLL PC DEBUG