OutBack Power Installation and User Manual

17
Soft Key Related Abbreviations
ADV-Advanced INC-Increase 
AGS–AdvancedGeneratorStart INV-Inverter
AUX–AuxiliaryOutput MIN-Minutes
BATT–Battery PG1,PG2,PG3,PG4-PageOne,PageTwo,etc.
CAL–Calibration RSET–Reset
CHGR–Charger SETP–Setup
CNT-Contrast SRCH–Search
COMM–Communication STAT–Status
DEC-Decrease SUMorSUMRY-Summary
DISCON–Disconnect TMRS-Timers
EQ–Equalize WARN–Warning
GEN–Generator P01—MasterFX
HBX–HighBatteryTransfer PO2,PO3,etc.-SlaveFXs
How To Read a MATE Screen
MATE screens will either show values that can be changed or navigate to value screens. e
informationontheMATE’sscreenissegregatedbytypeortaskanddistinguishedbylocation
on the screen and the choice of lowercase or uppercase letters. Occasionally it can be misread
byauser.efollowingexampleisshownforclarication.
Left side: shows a
condition, value label,
system feature, or
measurable event
Right side: status,
setting, or measure
of value for whatever
appears on the left side
Top line: where you are in the system and what HUB
Port you’re viewing. In this example, the STATUS of
the Port 1 FX METERS output voltage is displayed.
Bottom line: soft key commands allowing the
user to change screens or alter a condition,
feature, or event or change ports if using a HUB.
STATUS/FX/METERS----------P01
output 122 VAC
voltage
DOWN UP TOP PORT
HUB Port