Installation Manual Owner manual

63
LOW-VOLTAGE WIRING
A switch can be wired to the INVERTER
and ON/OFF terminals to manually
control the FX
XCT+/XCT- are not operational
12 VDC at 0.7 amps (8.4 watts) is available
at the AUX+/AUX- terminals
This six-position terminal block can be
unplugged to make wiring easier and to
simplify the removal and reinstallation of an FX.
It must be securely and completely plugged
in for proper FX functioning. Otherwise,
operational errors can occur.
INVERTER and ON/OFF
• Replacingthepre-installedjumper(connectingtheON/OFFterminals)withaswitchallowsmanualcontrolof
the FX.
• Whenajumperisinstalledineitherlocation,theinverterwillbeON.
• Whenaswitchisinstalled,theinverterisONwhentheswitchisclosedandOFFwhentheswitchisopen.
•WhenasystemisorderedwithaMATE,theMATEhandlesallFXON/OFFfunctions.
Control Wiring Terminal Block,
side view
INVERTER ON/OFF
Jumper







  


 









Control Wiring Terminal Block