Installation Manual Owner manual

54
MOUNTING
•TheFXSeriesInverter/Chargerisapprovedforindoororenclosedprotectedmountingonly.
•AnFXmustbesecuredwithappropriatefastenerstoasturdymountingsurfacecapableof
supporting its weight. It is easier for two people to install the FX due to its weight.
•OutBackFXscanbemountedinanyposition,buttheyperformbetterinlocationsoeringplentyof
air circulation.
•NOTE: If using an OutBack FLEXware Mounting Plate, avoid large air gaps behind the plate which can
result in louder mechanical noise during inverting/charging under heavy loads.
•Duetothevarianceinothermountingmethods,OutBackonlyendorsestheuseofFLEXwareor
previous versions of its mounting plate for installing the FX and associated system components
using M6 X 20mm machine screws (stainless steel for FLEXware and self-tapping for older mounting
plates), one per corner. Follow the instruction manual that comes with each mounting system.
•IfmountingtheFXonothersurfacessuchasplywood,wallstuds,ormasonry,useappropriate
fasteners to support approximately its weight. OutBack cannot be responsible for damage to the FX
if it is attached with inadequate fasteners.
•InstallandsecureeachFXbeforeattachinganywiring.
•InsertappropriatefastenersatallfourcornersoftheFXforasecureinstallation.
• Weight varies from 56-62.6 pounds (25.40 - 28.395 kg) depending on the model
20.955 cm (8.25””)
32.03 cm (13”)
41.275 cm (16.25”)