Manualshelf

OutBack Power Installation Manual

ManualsBrandsOutBack Power Systems ManualsBalance of SystemOutBack Power Radian Series Load Center
21222324252627282930
Installation
28 900-0123-01-00 Rev C
Mounting the HUB Communications Manager
The GSLC provides mounting holes to support a HUB Communications Manager.
Figure 25 Mounting the HUB Product to the GSLC Enclosure
To mount the HUB Communications Manager to the side of the GSLC enclosure:
1. Locate the mounting holes on the side of the GSLC enclosure as shown in Figure 11 on page 16.
2. Remove the knockouts and add bushings.
3. Align the HUB (vertically) over the mounting holes with the HUB product’s ports facing forward.
4. Insert the mounting screws from the outside into the GSLC enclosure. The mounting screws are provided
with the HUB product.
5. Tighten until secure, but do not over-tighten.
6. Install CAT5 cabling as needed.
7. Install the protective shield for the HUB product.
Mounting
Screw
Mounting
Screw