OutBack Power Installation Manual

Assembly

900-0123-01-00 Rev C 25

Mounting on the Inverter

IMPORTANT:

The Radian inverter and GSLC are intended for indoor use only. Ensure that the

mounting surface is strong enough to support the full weight of the Radian

inverter/charger and the GSLC. Use a minimum 3/4" (19 mm) sheet of plywood to

strengthen the wall surface if required.

Figure 23 Mounting the GSLC

To mount the GSLC to the Radian inverter:

1. Install the Radian inverter on the mounting bracket.

Remove knockouts from the bottom of the Radian inverter

if necessary and install bushings.

2. Back out bottom screw(s) approximately 1/4" (0.6 cm) to

3/16" (0.5 cm).

3. Remove the front and interior covers from the GSLC if

necessary (as described on page 18).

4. Align the GSLC along the bottom of the inverter and slide

the bottom screws into the keyhole slots.

5. Hanging the GSLC from the screws and holding it flush

against the bottom of the inverter, mark the spots for the

holes for the mounting feet. These are located in the rear

of the GSLC and are marked below.

6. If using wall anchors (included): Remove the GSLC. Using a

3/8" (10 mm) drill bit, drill leader holes for the hardware to

be used to secure the GSLC to the surface. Install the wall

anchors. If mounting on a solid surface like plywood, this

step can be skipped.

Bottom Screws

Mounting Feet

Holes (x4)

14"

(35.6 cm)

12.5"

31.8 cm

Continued on the next page....

Keyhole Slots