OutBack Power Installation Manual

Assembly

900-0123-01-00 Rev C 19

Remove Interior Cover

In order to make any wiring connections or to install components, the interior cover must be removed

to expose the interior of the enclosure. (This cover is sometimes called the “dead front.”)

Figure 16 Removing the Interior Cover from the GSLC

Installing the Internal Hardware

Table 1 Size and Torque Requirements for Circuit Breakers and Bus Bars

Item

Terminal/Bolt Size

Torque Requirements

Inverter Positive (+) Bus Bars M8 60 in-lb (6.8 Nm)

Shunt Bolts 3/8" 60 in-lb (6.8 Nm)

DC Positive (+) Cable Plate Top Holes (x3) 60 in-lb (6.8 Nm)

Bottom Holes (x7) 50 in-lb (5.7 Nm)

Circuit Breaker Studs M8 20 in-lb (2.3 Nm)

1/4" 35 in-lb (4.0 Nm)

5/16" 50 in-lb (5.7 Nm)

3/8" 225 in-lb (25.5 Nm)

Figure 17 DC Positive Cable Plate (FW-BBUS)

To Remove the Interior Cover:

1. Remove the three screws along the top of the enclosure

(with one star washer).

2. Remove the three screws along the bottom of the

enclosure (with one star washer).

3. Lift the front cover off the enclosure.

Remove (x3)

Interior

Cover

Top Holes

Bottom Holes

0.5" (12.7 mm)

0.31" (8 mm)

0.4" (10 mm)

NOTE: The DC Positive (+) Cable

Plate (FW-BBUS) is not included

with model GSLC175PV1-120/240

or model GSLC175PV1-230. It

cannot be used with these models.