OutBack Power Installation Manual

Installation
18 900-0123-01-00 Rev C
Remove Top Cover
Figure 14 Removing the Top Cover from the GSLC
Remove Front Door
Figure 15 Removing the Front Door from the GSLC
To Remove the Top Cover:
1. Remove the four screws; one in each corner.
2. Lift the top off the enclosure.
Enclosure with
Top Removed
Lift up to remove.
To Remove the Front Door:
1. Open the door to about 90 degrees.
2. Lift the hinges out of the slots at the
inside edge.
Open to 90 degrees
(shown partly open)