OutBack Power FLEXpower ONE FXR Series Quick Start Guide

L1
L2
NEUTRAL
GROUND
AC Source
(single)
General Wiring
Ground Electrode
Conductor
HOT
NEUTRAL
GROUND
Bypass
Output
Input
Outlet
PV Combiner Box
900-0132-01-01 REV A.vsd
©2013 OutBack Power Technologies. All Rights Reserved.
AC Subpanel
N
N
L1
L1
L1
L1
N
N
Photovoltaic Array (PV)
Battery Status
GFDI
AC IN
INV
MAIN----------------
3:02:14P
SUM STATUS SETUP ADV
Battery Bank
Vented Battery Enclosure
MATE RTS
(RTS)
In 23.2 V 0.0 A
Out 27.6 V 0.0 A
0.000 kW 0.0 kWH
AUX: OFF Sleeping
PV Circuit Breaker
Connects to the terminal on the circuit breaker
that is opposite the inverter DC cable.
1
Charge Controller
1
Loads
(120 Vac)
If the FLEXnet DC battery monitor
is not installed, the DC shunt will
not be installed.
If the DC shunt is not installed,
connect the DC negative (–) cable
directly to the DC negative (–)
terminal on the inverter.
MATE RTS
AC HOT OUT
AC NEUTRAL OUT
CHASSIS GROUND/PE CHASSIS GROUND/PE
AC NEUTRAL IN
AC HOT IN
O
I
O
I
O
I
O
I
O
I
O
I
O
I
O
I
AC Distribution
Panel
60 A Circuit
Breaker
(Maximum)
IMPORTANT: Example only.
Actual wiring may vary. Factory wiring not shown.
All configurations must comply with local and national electric codes.
Consult your local electric authority to ensure compliance.
Neutral
HOT L1
Ground
AC LEGEND
L1
N
(or disconnect device)
IMPORTANT:
Indoor installation only.
2
2
DC Negative (—) Cable
DC Negative (—)
Terminal on the
Inverter
Negative
Positive
Ground
DC LEGEND