Installation Manual Owner's manual
Installation
DC Enclosure
Front Cover
Lip
Notch
1. Align the holes in the DC Enclosure Front cover
with the holes in the chassis. Ensure that the
“lip” fits into the notch in the chassis.
2. Replace the screws removed in the beginning.
To Replace the DC Enclosure Front Cover:
Cabling not shown.
Figure 25 Replacing the DC Enclosure Front Cover
DC Cover
3. Replace the screws
removed in the beginning.
2. Align the holes in the DC Cover as shown.
To Replace the Inverter’s DC Cover:
1. Replace the plastic Battery Terminal Covers.
Cablin
g
not shown.
Figure 26 Replacing the DC Cover
900-0095-01-00 Rev A
37