Installation Manual Owner's manual

Installation
Accessing the Wiring Compartments
Inverter Terminal Enlargement
Internal components may vary from model to model.
Factory wiring is not shown.
AC Input, Output, & Bypass
Breakers (x3)
(120-NA: 60 A)
(230 EU : 30 A)
Mechanical Interloc
k
Breaker for AC Outlet (X1)
120-NA: 20 A
23-EU: 16 A
AC Outlet (X1)
T
erminal Bus Bar for
Neutral Connections
AC Ground Bar
DC Ground Bar
Battery Disconnect
(125, 175, or 250 Adc)
GFDI Breaker (1 Adc)
PV Disconnect (80 Adc)
Battery Positive (+)
Battery Negative (–)
Breaker for FNDC (1 A)
(if installed)
Shunt A
1
1
Required by FLEXnet DC Monitor. Shunt A monitors inverter input and output
current. Shunt B monitors PV input current. Shunts are not present if the
FLEXnet DC Monitor is not part of the configuration. Shunt B is not present if the
FLEXmax 80 Charge Controller is not part of the configuration.
Shunt B
1
FLEXmax 80
Terminal Block
Enlargement
FLEXnet DC Monitor
(If installed)
Figure 12 Wiring and Breaker Compartments
900-0095-01-00 Rev A
25