Installation Manual Owner's manual
Planning
20 900-0095-01-00 Rev A
Conduit and Knockout Preparation
Knockouts (two 1”, one 2”) are provided on the ends of the AC and DC enclosures for routing cable
into the enclosures. Conduit and bushings are recommended to prevent damage to conductors from
sharp edges along knockout holes.
1. Remove the 2” knockout on the DC end to accommodate the larger battery cables and Remote
Temperature Sensor cable.
2. Remove the 1” knockout(s) on the AC end to accommodate the AC cabling.
3. Install conduit and bushings to protect the cable from damage from the sharp edges of the hole.
4. Ensure no debris or metal shavings have fallen into the enclosures.
Figure 8 Conduit and Knockout Preparation
1”
2”
AC End
DC End
Bottom View
Front Side
Front Side
T
op View
1”
2”