Instruction Manual

2



GENERALSAFETYINFORMATION



!DANGER

• Failure to disconnect the power source before installation or servicing  can result in serious injury or

deathfromelectricshock.



− Alwaysdisconnectthepowersourcebeforeservicingorinstallingthehanddryer.

• Failuretoproperlygroundthisunitcouldresultinsevereelectricalshockand/ordeath.

− This hand dryer must be properly grounded (Earthed) for safe operation. An identified ground

connectionpointissuppliedonthechassis

ofthehanddryer.

− WerecommendGFCIprotectioninwet ordamplocationsorasrequiredbylocalcode.



!WARNING

• Risk of fire, personal injury or property damage are possible if local codes, national codes, or safety

recommendationsarenotfollowed.

− Useonlytheelectricalpower(voltageandfrequency)specifiedforthemodelhanddryerbeinginstalled.

− Connectthehanddryertothenearestsuitabledistributionpanel.

−

Tolimitavoltagedrop, andensureefficientoperation,useNo.12wireorlargerasrequiredbylocalor

NationalElectricalCode.

− Donotconnecttoabranchcircuitwithcircuitbreakerorfuseprotectionover15Amps.

− Allautomaticmodelhanddryersmusthavededicatedcircuit.

− Routeallfieldwiringawayfrommovingpartswithinthehanddryer.

!CAUTION

• Impropermountingcouldresultinpersonalinjuryorpropertydamage.

− FollowthemountingrecommendationsinTable1.

− Onastudwall,onesideofthehanddryershouldbemountedtoanexistingstud.

INSTALLATION



IMPORTANT: Consult local and national regulations before performing dryer installation. Ensure that the

electricalnetworkisnotoverloaded.Donotconnecttoabranchcircuitover15amps.

1. Disconnectthepowersource.

2. Usethe securityhexkey supplied to turnthecover mounting screwsclockwisetoremove thecover

from

thedryer.

3. PlacethehanddryerbaseonthewallatthedesiredlocationusingTable1todeterminetherecommended

mounting height. With thebase so located,use it as a template to marklocati onsof the 4 mounting bolt

holesonthewall.Ensurethatnoreflectiveobject

(suchasahandbasin)islocateddirectlyunderinfra‐red

sensoreye;theminimumdistanceis18 inches(46cm).

4. Fastenthebasetothewall,usingthetypeofboltssuggestedinTable2.

5. Allautomaticdryersmusthavetheirowndedicated15ampcircuit.

Connectthedryertothenearestsuitabledistributionpanel.

7. Replacecover,turnscrewscounter‐clockwisemakingcertainnottoover‐tighten.