User's Manual

device does not have a display and multiple devices are being

paired with multiple speaker mics, only put one device into

pairing mode at a time to avoid pairing the Bluetooth Revo NC2

™

with the wrong device. The speaker microphone will emit a tone

when pairing is successful and the blue light will ash 10 times.

4. Pairing mode will time out after 150 seconds if the unit is not

successfully paired with a device. Repeat steps 1-4 to attempt to

pair again. Kenwood radios: After “Connect” is chosen in the

radio menu to connect to the Bluetooth Revo NC2

™

, the radio

will “call” the microphone and ring tones will be heard on the

speaker mic. “Answer” the call by pressing the multi-function

button once and releasing, and the radio will complete the

connection to the Bluetooth Revo NC2

™

5. The Bluetooth

Revo NC2

™

speaker mic retains pairing

information for as many as six devices. Check the Bluetooth

menu on the device to be sure the speaker microphone is paired

with the correct device.

6. Clearing the pairing memory is not essential, but it can be done as

desired. To clear the memory, perform the following operation:

• Press the multi-function button once and release.

• As soon as the blue/purple lights on the back of the speaker

mic light up (after approximately two seconds), press the PTT

button once and release. After a few seconds, a set of tones

will be heard. The memory has been cleared.

OPERATION, CONTINUED

Bluetooth

REVO NC2

™