User's Manual

5
OPERATION
Figure 1
Charge the Speaker Microphone
The Bluetooth
®
Revo NC2
™
is powered by an integrated rechargeable
battery. The battery should be fully charged before rst use.
• Plug the charging cable into the Micro-USB
charging port on the back of the unit (Figure 1).
Plug the other end of the cable into a USB port
in a computer, vehicle, or wall charger.
• The red indicator light will show solid red
while charging and will turn off when the unit
is fully charged. Battery charge time is approximately 3 hours.
• The rechargeable battery will supply approximately 12 hours of
service before recharging is needed.
• Low battery is indicated by a ashing red indicator light.
Power On/Off the Unit
• Push and hold the multi-function button for 3 seconds or until
the red and blue indicator lights ash 3 times and you hear a
series of tones. When power is on, the blue light will ash once
every 3 seconds until the unit is paired.
• To turn off, push and hold the multi-function button for 6
seconds until you hear a different series of tones.
• If the speaker mic is not paired with a device within 5 minutes,
the unit will automatically power off to conserve the battery.
• Wait 5 seconds after the unit powers down before turning it
back on to attempt to pair again.
Bluetooth
®
REVO NC2
™